3/17/2024 0 Comments Arc flash boundary calculator![]() In up to 2% of incidents, serious injury, incurable burns to the torso, and death could result. The methods for determining incident energy exposure from this IEEE 1584 standard were created so that the level of PPE selected from the calculated incident energy would be adequate to protect the torso against incurable arc flash burns for 98% of arc flash incidents. The calculations and data in this calculator and procedures used for determining incident energy exposure, level of PPE, and flash protection boundary are based upon IEEE Standard 1584, Guide for Performing Arc Flash Hazard Calculations (23 September 2002). Workers must also be protected against these hazards and therefore additional investigations and additional personal protective equipment may be required. The output of this calculator does not address the worker protection required against the effects of pressure, shrapnel, molten metal spray, or the toxic copper vapor resulting from an arc fault. This information is intended to help assist in determining the proper flash protection boundary and level of PPE to help safeguard a worker from the burns that can be sustained from an arc flash incident. General notes for fuses and circuit breakersįirst and foremost, the information found in this calculator, or in any other calculator, is not to be used as a recommendation to work on energized equipment. We disclaim any liability for the use of this software, calculations or other information. The software, calculation results and other information are provided without warranty of any kind, either expressed or implied, but not limited to, the implied warranties of merchantability, or fitness for a particular purpose. However, any and all liability for the content, or any omissions from this website, including any inaccuracies, errors, or misstatements in such data, calculations or information, is expressly disclaimed. The data and information presented in this website and/or calculator are believed to be accurate. We also reserves the right to change or update, without notice, any technical information contained on this website. We reserve the right, without notice, to change this program and to discontinue or limit its distribution. This software program, calculations, and other information are intended to clearly present technical information that will help the user determine the thermal arc flash hazard. ![]() If you do not agree, then close this page and do not enter the Arc Flash Calculator page. To proceed to the calculator site, you must have read the Notes and read and agree to be bound by all terms and conditions on this page and the Terms of Use (TERMS AND CONDITIONS AND LEGAL NOTICES) and Legal Notices of this web site. We strongly recommend that you read the notes below before clicking the acceptance button. To use the Bussmann series online Arc Flash Calculator, a registration is required and your browser must accept cookies. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |